Forum Discussion

🚨 This forum is archived and read-only. To submit a forum post, please visit our new Developer Forum. 🚨
Zothar's avatar
Zothar
Explorer
12 years ago

General 3D Models of DK2

Are there 3D models available of the outer dimensions of the upcoming DK2? I'm designing a Leap motion controller mount and wanted to be sure to avoid the LEDs on the outer shell and get the fitment right. Im trying a new semiflexible UV curable resin for my printer :)

Any help would be greatly appreciated.

Thanks,
Dan

4 Replies

  • baloniman's avatar
    baloniman
    Honored Guest
    12 years ago
    http://imgur.com/Z3PSSS2

    I did a rough look at the layout and picked where I think are the least intrusive spots to the LED's. That may help you a bit, I'd recommend putting it on the top portion then you could remove it with the cable cover. Also you have way more space available from LED's. There is a tight fit on the bottom and the surface is uneven so that will present some mounting challenges.
  • Zer0kewl's avatar
    Zer0kewl
    Honored Guest
    12 years ago
    "baloniman" wrote:
    http://imgur.com/Z3PSSS2

    I did a rough look at the layout and picked where I think are the least intrusive spots to the LED's. That may help you a bit, I'd recommend putting it on the top portion then you could remove it with the cable cover. Also you have way more space available from LED's. There is a tight fit on the bottom and the surface is uneven so that will present some mounting challenges.


    Perfect example of an awesome response :)
  • Zothar's avatar
    Zothar
    Explorer
    12 years ago
    Thanks for the great replies! I think ill wait until my dk2 comes in and design a replacement cable cover that has leap motion clips on it.

    Thanks again!