06-19-202409:56 AM - last edited on 06-19-202403:33 PM by AliceinVRworld
How do you stop or delay the Quest display from shutting off when you take the headset off.
Really hate this and all I can find online is people complaining about it since 2019.
Even 5 seconds delay would be better than what it does now.
Most of the time you take the head set off it’s not because you are done. It’s to give the headset to someone else, wipe your forehead, scratch your nose, etc.
Hi @CptV4d3n! We understand that you want to know how to keep the display on when you remove your headset. That's a great question! While we don't an official way to make this happen yet, we see that a lot of our users have found a workaround. Some have stated that they just place their finger over the sensor, while others say they use a piece of tape over the sensor. We hope this information helps you! If you need further assistance, don't hesitate to reach back out!
If you're the author of a thread, remember to mark a reply as the Accepted Solution to help others find answers!
