I recently got an oculus quest 2 and an oculus link I connected the oculus link it did work but I pressed allow when I should have pressed deny because I didn't watch any guide and I'm trying to connect to the oculus app but I can't redo the oculus link setup If someone could tell me how I could redo it that would be helpful
Hi McEgoo, that's great that you got an Oculus Quest 2. We want to get this resolved for you, so let's see why your Oculus Link is doing this.
If you'd like to use Oculus Link to connect your Quest 2 or Quest to a PC, you'll first need to download the Oculus PC app by visiting oculus.com/setup and clicking Download Software below Oculus Link. You should also review the Oculus Link compatibility requirements and confirm the following:
Your PC meets the recommended specs.
You're using a high-quality USB cable capable of supporting data and power.
Your Oculus software is up to date on both your PC and your headset.
Once you've confirmed these requirements, you can begin using your Quest 2 or Quest with Link:
Open the Oculus app on your PC.
Turn on your Quest 2 or Quest.
Plug your USB 3 cable into a USB 3.0 port on your PC, then plug the other end into your headset.
A message displays in VR prompting you to Allow access to data. Select Deny. If you mistakenly 'Allow' the prompt, you must unplug your USB cable from the headset and plug it back in.
When prompted to Enable Oculus Link, select Enable to begin remote rendering using Oculus Link.
If you're unable to enable Oculus Link:
If you don't see Add Quest as the device on the PC software: log out of the PC software and log back in.
If you don't see the Enable Link pop-up on the PC software: log out of the PC software and log back in.
If you don't see the Enable Link option under Settings on your headset: completely power off the headset and restart.
Let us know if these troubleshooting steps were able to help you!
If you're the author of a thread, remember to mark a reply as the Accepted Solution to help others find answers!
