I increased my Quest 2 resolution to 3072 using SideQuest. When I look at my home screen (virtual environment), I can see the menus just fine, but I can only see a small patch of the virtual environment where I'm looking. I have put the visor to sleep and back again, but it stays the same. I haven't seen anybody address this in all the "increase your resolution" videos I've watched. Restarting the headset restores the defaults.
Has anyone else had this issue and if so, were you able to fix it?
I've had the same problem too. I thought I had a faulty cable, so I went ahead and bought a third party cable (KIWI Design) and it still didn't fix the problem. I would adjust the resolution, turn the device to sleep, turn it back on and the screen would shift to the left and I'm left with blackness on the right and bottom sides of my screen.
