Is there any way to skip the touch tutorial? I've done it 3 times now (making changes to my setup) and the only way I have found to get out of it is with task manager, using a forced end.
Which kind of change setup you made 3 times? If it's "just" sensors placement you just have to run again the "Reset Sensors Configuration", not the whole configuration...
“Dreams feel real while we are in them, it's only when we wake up that we realize something was strange.” - Dom Cobb
"Be careful, if you are killed in real life you die in VR too." - TD_4242
I7 10700K, RTX 4070 TI Super, 64GB DDR4 3200Mhz, Oculus Rift CV1 and Quest 3
Sometimes big moves recommend a full setup, in which case it forces you to go through First Contact. Its a neat demo but I agree with OP. It should let you skip that endeavor unless you want to let someone else mess with it
Each time I change between my 2 gaming rooms (for the week end) it's a pretty big move, sensors not on same height (from desk to 1m80 high) not the same place at all (from 1m30 to 2m20 in between), the whole system is turned 180 degrees, even exchanged sensors left and right to try : all work flawlessly just after a "center reset" without doing anything but guardian (obviously, play area change from 2mx2m to around 2m80x2m25). So I just have to redo the Sensors position, guardian,and that's all. I never had a message saying it move too much and I need to do the full round. At least that's with my configuration, I can understand it's painful if OH say you have to go full setup...
Edit : Like the DreamDesk, First contact is copied 2 times in our installation, one for the setup in (for me) "D:\Oculus\Support\oculus-touch-tutorial" and the other one loaded from my Library in "D:\Oculus\Software\Software\oculus-first-contact". I guess replacing the "TouchNUX.exe" from the Support directory can shorten your experience (I don't assume possible consequence, backup first) 😉
Edit2: Saying that, I'm not sure which EXE should be changed here, batch file goes in sub-directories to launch it, so be careful if you messing around here...
“Dreams feel real while we are in them, it's only when we wake up that we realize something was strange.” - Dom Cobb
"Be careful, if you are killed in real life you die in VR too." - TD_4242
I7 10700K, RTX 4070 TI Super, 64GB DDR4 3200Mhz, Oculus Rift CV1 and Quest 3
Which kind of change setup you made 3 times? If it's "just" sensors placement you just have to run again the "Reset Sensors Configuration", not the whole configuration...
I upgraded my mobo and so every item got a new usb port, all usb3 now, so I got the prompt asking me to set up my stuff. I think I can just skip it if it happens gain. I since added a 3rd sensor and only had to reset sensors.
