My Meta Quest which is just over fourteen months old developed a fault
at the beginning of October this year whereby it would not work with
Airlink or a link cable. Since then, starting on the 17th of October, I
have been in contact with Meta support...
I have just started getting the following error message on my Quest2.
"Dash encountered a fatal error. Please reload dash to continue. Press
any button to reload dash" This seems to be an intermittent fault. It
recently occurred when I was using FS20...
I only ever use my headset when seated and have set the boundary as
such. For some reason though I always have a blue boundary semi circle
on display. This applies across the board including FS2020 which is
doubly annoying. Any help is welcome.
The blue boundary line is always on when I use my Quest2. I only ever
use the headset in seated mode and do not seem to be able to get rid of
it even when using MSFS 2000. I only ever use the Airlink if that is of
relevance. Any advice welcome as it ...
I have just bought an Oculus quest 2 with the intention of mainly
running FS2020 on it. I have downloaded the PC app and have connected
the headset using a cable but whenever I try to switch to VR on the sim
I get a message saying that no headset has...
It would seem that changing the batteries in the handset did the trick.
However, just after that was sorted I upgraded my computer and getting
Oculus to work on my new set up was a bit of a nightmare. Luckily the
Oculus help line was very good, and t...
Actually yes I am getting that minified message on the Oculus website.
The low batteries may be the clue as I am also getting a low battery
warning for my right hand controller. I will check that out when I get
the chance. It sounds a bit implausible...
I have tried contacting Meta support about this but without much
success. To my mind, they should be able to recognise the error message
and give advice accordingly. But no they ask for all sorts of
screenshots etc. In the end, I gave it up as a bad ...
