Hey Guys - I was an early adopter for the Oculus Rift CV1 and for the
past few months have had an annoying issue. The face interface (which
may purposefully be removed) does not stay connected to my headset. I
don't remember if there was any "snap" o...
Hey Guys - Just opened a Support Ticket, but wanted to post here as
well. When using my Rift for a couple of hours yesterday, it all of a
sudden started flashing black and sometimes static frequently and
randomly. Since then, I've tried the below to ...
Hey Guys - Been a Rift CV1 owner since before the touch controller's
release and love it. I'm wishing to upgrade my hardware to improve
detail & performance in many titles. Even Oculus Home runs in "Low"
without ambient occlusion. My system is custom...
Hey Guys - After having many issues with tracking recently (especially
since I cannot get past Request Timeout errors when recently setting up
again), I am considering moving all 3 of my sensors. Below are two scale
diagrams of my room where my PC is...
Hey Guys - I've had my Rift CV1 since way before the touch controllers
were released and love it. A couple of weeks ago, the connector on the
Rift which the top head strap loops through broke off :(. There's a
little rod which can normally be removed...
Thanks, but tried both suggestions already. Have tried to click it in
each time I use it for months plus have purchased 2 aftermarket
interfaces. Does anyone know of pictures or schematics showing
components of HMD that hold it in place? I've found t...
Hey Guys - You were correct, falken76. After a bit more testing, I found
that bending the cable at about the point where it's clamped to the HMD
was the cause. I reported this information back to Support. Out of
warranty, so hopefully they are now se...
UPDATEThe update which reverted Oculus back to the non-Preview version
(1.41.0.295808 (1.41.0.295808)) completed so I tested again. Initially,
I though it was better and was able to play for about a minute. After
that it started again and kept gettin...
Thanks guys - I read all replies and have just three more questions,
please...1. CPU Bottlenecking I totally understand that a GPU may be
limited by CPU. Given that, if I were to upgrade to something like a
1080ti and keep the 3770k, will that occur ...
Not sure about JBWeld & similar as although I've used it for multiple
things in the past, I'm not sure about its adhesive properties with
plastic. Worst case, you could do what I did with Bondic and mold what
you want with JBWeld then use something l...
