quest 3 keeps turning off and on by itself repeatedly, but when back on, no controllers/hands work.
Quest 3 manufactured in December 2023 keeps turning off and on during use, usually after using a data cable either from my pc or from my piano's usb output (for midi which incidentally I can't get to transmit). Each time it comes back on, I'm presented with the pin screen, but I'm only able to move the pointer with my headset, not with my controllers or hand tracking. If I move my head more than 30 degrees I can no longer move the points, and if I press a button on the controller I can no longer move the controller, but repeatedly pressing the button on the controlller after I cant move the pointer, still causes the onscreen pointer dot to flash in response. A few seconds later it will turn off and then repeat the above process. Powering off the device and restarting it seems to allow it to work for a little while before it does it again. I'm not doing anything intensive in it, just meta workroom, and the first time it happened was in PianoVision. Battery is full charged. I've only had the unit 2 days. It's not overheating, because the first time it happened I'd only just turned it on. Strange thing is, since installing the meta remote desktop onto the PC, I experienced a similar issue with my PC when trying to take it out of sleep mode this morning. I think this might be coincidental though, because I wasn't using airlink when it first happened in PianoVision. Could the repeatedly going in and out of standby and the failure to receive midi be caused by a faulty usb-c socket on the quest 3?22KViews0likes30CommentsQuest 3 Left controller wont update
It was working fine and then stopped. It tried to do a firmware update and it will make it to 66% and then reset, does this 3 times and then fails. Tried all of the “fixes” I.e. unpair, factory reset, batteries, but it will not work. Any other solutions??Solved24KViews2likes48CommentsSlow charging on Meta Quest 3
The first times I charged the Meta Quest 3, it charged quickly. I've heard about 2 hours for full charge, and quicker of course in the beginning. That seems on-par with my experience. But now, after a couple of charges up to 50-80%, it suddenly charges super slowly. It went from 9% to 19% in almost two hours. I tried to connect it and disconnect it several times, but it still charges super slowly. It's now 20% (from 19%) in 15 minutes. What is going on? I'm using the official charger, but I did try with another one as well with the same result. What is wrong?Solved112KViews9likes27Comments