Ended up Stuck trying to update a fresh Santa Cruz Dev Kit to Firmware that works with Oculus App
So I was trying to ramp up a santacruz devkit we had on hand that had not been previously opened. But I could not pair it with the current user-flow on the oculus app on a phone. Going through the provided documentation I was able to confirm it worked through skipping the first user experience via ADB commands suggested and able to get it access to a wifi network and begin updating the firmware. However I've reached the point where if I turn on the head set I end up with a 'downloading' screen for updating the Headset, but it does not immediately show a progress bar, and eventually only shows a half full progress bar that never (within the last six hours of the work day) updates. I am not sure but I suspect that I've managed to get my Santa Cruz into a bad state, does anyone have advice on a shell command to restart/force the HMD update or a way to reset to factory settings via ADB? The only other thread I can find related to this magically resolved itself without any clarification on how or why. Any help would be appreciated. oculus/vr_monterey/monterey:7.1.1/NGI77B/256550.5350.0:user/release-keys ------------------------ BEGIN SERVER STATE ------------------------ Battery Level: 100 Charging: true Fast Charging: true Wifi enabled: true Wifi configured: true Wifi connected: true Wifi server reachable: true Wifi IP address: 192.168.2.8 Wifi device name: Controller primary configured: true Controller primary connected: true Controller secondary configured: true Controller secondary connected: true Controller other configured: false Controller other connected: false OTA available: false OTA ready: false HMD Update percentage: 50 PIN configured: false PIN locked: false Horizon logged in: false Developer mode: false ADB: true HSW complete: false NUX complete: true NUX State: DAY0_OTA_READY Headset State: STANDBY ------------------------- END SERVER STATE -------------------------