quest 3 keeps turning off and on by itself repeatedly, but when back on, no controllers/hands work.
Quest 3 manufactured in December 2023 keeps turning off and on during use, usually after using a data cable either from my pc or from my piano's usb output (for midi which incidentally I can't get to transmit). Each time it comes back on, I'm presented with the pin screen, but I'm only able to move the pointer with my headset, not with my controllers or hand tracking. If I move my head more than 30 degrees I can no longer move the points, and if I press a button on the controller I can no longer move the controller, but repeatedly pressing the button on the controlller after I cant move the pointer, still causes the onscreen pointer dot to flash in response. A few seconds later it will turn off and then repeat the above process. Powering off the device and restarting it seems to allow it to work for a little while before it does it again. I'm not doing anything intensive in it, just meta workroom, and the first time it happened was in PianoVision. Battery is full charged. I've only had the unit 2 days. It's not overheating, because the first time it happened I'd only just turned it on. Strange thing is, since installing the meta remote desktop onto the PC, I experienced a similar issue with my PC when trying to take it out of sleep mode this morning. I think this might be coincidental though, because I wasn't using airlink when it first happened in PianoVision. Could the repeatedly going in and out of standby and the failure to receive midi be caused by a faulty usb-c socket on the quest 3?