Skip to main content
Zothar
Participant
July 22, 2014

General 3D Models of DK2

Are there 3D models available of the outer dimensions of the upcoming DK2? I'm designing a Leap motion controller mount and wanted to be sure to avoid the LEDs on the outer shell and get the fitment right. Im trying a new semiflexible UV curable resin for my printer :)

Any help would be greatly appreciated.

Thanks,
Dan

    4 replies

    baloniman
    Up and Coming
    July 23, 2014
    http://imgur.com/Z3PSSS2

    I did a rough look at the layout and picked where I think are the least intrusive spots to the LED's. That may help you a bit, I'd recommend putting it on the top portion then you could remove it with the cable cover. Also you have way more space available from LED's. There is a tight fit on the bottom and the surface is uneven so that will present some mounting challenges.
    Zer0kewl
    Participant
    July 23, 2014
    "baloniman" wrote:
    http://imgur.com/Z3PSSS2

    I did a rough look at the layout and picked where I think are the least intrusive spots to the LED's. That may help you a bit, I'd recommend putting it on the top portion then you could remove it with the cable cover. Also you have way more space available from LED's. There is a tight fit on the bottom and the surface is uneven so that will present some mounting challenges.


    Perfect example of an awesome response :)
    cybereality
    Inspiring
    July 23, 2014
    See this thread: viewtopic.php?f=26&t=10321
    AMD Ryzen 7 1800X | MSI X370 Titanium | G.Skill 16GB DDR4 3200 | EVGA SuperNOVA 1000 | Corsair Hydro H110i Gigabyte RX Vega 64 x2 | Samsung 960 Evo M.2 500GB | Seagate FireCuda SSHD 2TB | Phanteks ENTHOO EVOLV
    ZotharAuthor
    Participant
    July 23, 2014
    Thanks for the great replies! I think ill wait until my dk2 comes in and design a replacement cable cover that has leap motion clips on it.

    Thanks again!
    Terms & ConditionsAccessibility statement